6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MANUAL OPERATION
The pump can also be switched on
manually by inserting the sensor into
the socket on the side of the pump.
NOTE: If the sensor is inserted into the
socket, the pump will run
continuously.
NOTE:
Do not allow the pump to run
dry.
POSITIONING THE PUMP
1. Place the pump on a flat surface in the area that you want to drain.
• If there is sediment in the operating area, the pump should be placed
vertically on house bricks, or similar.
• ALWAYS raise and lower the pump using a rope attached to the lifting
handle.
• Take all necessary precautions as described on page 3.
USING THE PUMP
1. Connect the mains plug to the mains supply.
• Always use a high sensitivity residual current device (RCD) which has a
tripping current of less then 30mA.
2. Switch the mains power supply on.
• The pump will begin to drain water.
3. When pumping is finished, disconnect the pump from the mains power
supply.
IMPORTANT: Do not allow the pump to run dry
WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE, DO NOT USE THE
PUMP IF IT IS DAMAGED IN ANY WAY.
Summary of Contents for psp125b
Page 12: ......