13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
STARTING THE POWER WASHER
Prior to starting, refer to your engine manual for proper starting procedures for
your engine type.
1. Make sure the engine has sufficient fuel. See page 10.
2. Check engine oil level. See page 10.
3. Turn water supply on.
4. Start the engine. See Engine Owners Manual for correct procedure.
NOTE:
If the engine does not start after two pulls, pull the trigger on the
gun to relieve the pressure.
5. Pull the trigger on the gun to start water flow.
• Stand on a stable surface and grip gun/spray wand firmly with both
hands.
• Expect the gun to kick when the trigger is pulled.
6. Release trigger to stop water flow.
NOTE:
The power washer will automatically go into bypass mode, in
bypass mode, the pump recirculates the water because the
trigger of the spray gun is not being pulled. If unit is left in bypass
mode for more than two minutes, the water temperature will rise
to a dangerous level and could damage internal components of
the pump.
WARNING: FAILURE TO TURN ON THE WATER COULD CAUSE DAMAGE TO
THE PUMP.
WARNING: DO NOT ALLOW UNIT TO OPERATE IN BYPASS MODE FOR
MORE THAN TWO MINUTES AT ANY TIME.
Summary of Contents for PLS195
Page 28: ......
