11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
Keep the machine clean by wiping off dust with a clean cloth, and
occasionally blowing the grinder through with compressed air. Always wear
protective goggles when blowing through with compressed air.
The grinding wheel may need trueing or dressing occasionally. Only dress the
wheel with a proper dressing tool, whilst wearing safety goggles or glasses. If in
doubt seek expert advice.
DRESSING THE WHEEL
When the abrasive wheels start to become clogged with debris, use the
dresser tool supplied to clean (dress) them.
1. Start the bench grinder running
2. Place the dresser tool on the tool rest with the dresser wheels facing the
abrasive wheel.
3. Slide the dresser tool forward until contact is made with the abrasive wheel
and maintain a light pressure to clean the debris from the abraisive wheel.
4. After dressing, adjust the tool rests and spark deflectors as necessary.
CHANGING THE LIGHT BULB
Remove the bulb by twisting it anticlockwise.
Replace with an identical bulb (12V, 10W, ES10 fitting) available from the
Clarke Parts Department.
WARNING: DISCONNECT THE GRINDER FROM THE MAINS SUPPLY BEFORE
FITTING REPLACEMENT WHEELS, CLEANING OR ADJUSTMENT.
Summary of Contents for Metalworker CBG6250L
Page 16: ......
