4
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
ASSEMBLY
GUIDE RODS, SAW FRAME AND BLADE
1. Attach the handle to the upright
part of the saw frame using the
two screws, with the nuts seated in
the handle moulding.
2. Connect the polymer guide
pieces to the saw frame assembly
as shown in Fig 1.
2. Insert the guide support rods
through the holes in each guide
piece as shown in Fig 2, noting
that two of the rods include a
small end stop. This must remain at
the top of the guide rod.
3. Slide a depth stop collar onto one
front and one rear guide rod from
below and lock in position with
the thumbscrew.
4. Lift the saw frame, complete with
guide rods, and place the guide
rods into their respective sockets
in the mitre angle carriage.
5. Tighten the grub screw for each
socket using a hexagonal key to
secure the saw frame/guide rod
assembly in place.
FIG 1
FIG 2
END STOP
DEPTH STOP
COLLAR
FIG 3
SOCKETS
WITH GRUB
SCREWS
FRAME
UPRIGHT
FIXING SCREWS
