9435 Winnetka Avenue North
•
Brooklyn Park, MN 55445
Phone: 800.253.0367
•
Fax: 800.825.2753
240 Superior Boulevard
•
Mississauga, Ontario, Canada L5T 2L2
Phone: 800.668.8400
•
Fax: 800.263.5111
The machine
doesn’t work
as it should?
The suction
doesn’t work
as it should?
The machine
doesn’t clean
as it should?
The brush
doesn’t work
as it should?
ATTENTION! Do not use the machine before you have read and understood the Instructions for Use Manual.
Troubleshooting
MA30
™
13B
1.
Adjust the brush pressure by turning
the regulation knob.
2.
Check for brush wear, and make
sure that it is installed correctly.
3.
Check to see if there is debris that is
preventing the brush from rotating.
(*) For these causes the maintenance
procedure must be performed by an
authorized Clarke Service Center.
For further information refer to the
Service Manual, available at any
Clarke Service Center.
1.
Check if the battery is charged.
2.
Check if the battery is correctly
fitting in the machine. (*)
3.
Machine fault indicated by LED’s
blinking. (*)
1.
Check to see if the solution filter is
dirty. Clean it if necessary.
2.
Check if the holes in solution
dispensers are clogged. Remove
them and clean if needed.
3.
Check to make sure the quick
connect valve is not leaking.
1.
Check if the recovery tank is full.
2.
Check if dirt and debris are clogging
the squeegee inlet and if the blades
are worn or damaged.
3.
Rinse the inside of the duct recovery
hose with water.
4.
Check if the float cage is clean.