11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
CLEANING
Clean the log splitter with a dry cloth to remove tree sap or dirt after each use.
HOW TO REPLACE THE HYDRAULIC OIL
NOTE:
Refer to the parts list and diagram starting on page 13 to identify
the parts mentioned in the following text.
1. Remove the tension springs and remove the table from hydraulic pump.
2. Use a 6mm inner hex wrench to remove the two inner hex screws that hold
the hydraulic pump to the base.
3. Lay the pump horizontal and remove the oil plug from the rear of the
pump.
4. Add hydraulic oil until the cylinder is approximately 3/4 full.
IMPORTANT: Only use CLARKE HYDRAULIC OIL, available from your nearest
dealer.
Part No:
1Ltr
-3050830
5Ltr
-3050835
5. Replace the oil plug and re-assemble the log splitter.
SHARPENING THE WEDGE
After using the log splitter for some time, sharpen the wedge with a fine-
toothed file and remove any burrs or crushed area along the cutting edge.
MOVING THE LOG SPLITTER
1. Hold the handles and tilt the log splitter backwards on to its wheels.
WARNING: MAKE SURE THAT THE RAM ON THE LOGBUSTER IS NOT UNDER
PRESSURE WHEN YOU ARE CLEANING, MOVING OR MAKING ANY
ADJUSTMENTS.
Summary of Contents for LOGBUSTER 9
Page 16: ......
