13
TRANSPORT AND STORAGE
MOVING THE LOG BUSTER
CAUTION: BEFORE MOVING THE LOG BUSTER, MAKE SURE THE BLEED
SCREW IS TIGHTENED TO AVOID OIL LEAKING.
• Lift the front of the log buster by the handle and move the log buster
to the woking area.
STORAGE
When you have finish working with your log buster
1. Disconnect the log buster from the mains supply.
2. Tighten the bleed screw.
3. Clean the unit down using a dry cloth.
TROUBLESHOOTING
PROBLEM
CAUSE
REMEDY
Fails to split logs
Log is improperly positioned.
Refer to "log buster Operation"
section on page 9
Wedge cutting edge is blunt.
Refer to "Sharpening Wedge"
section See page 12
Oil leaks
Contact the dealer
Unauthorized adjustment was
made on Max. Pressure
Limiting Screw.
Contact the dealer.
The log pusher
moves jerkily
Excessive air in the hydraulic
system.
Check oil level for possible oil
refilling. Contact the dealer.
Oil leaks
around
cylinder ram or
from other
points.
Air sealed in hydraulic system
while operating.
Loosen Bleed Screw by 3- 4 turns
before operating the log buster.
Bleed Screw is not tightened
before moving the log buster.
Tighten the Bleed Screw up before
moving the log buster.
Oil Drain Bolt is not tight.
Tighten the Oil Drain Bolt.
Hydraulic Control Valve
Assembly and / or seal(s) worn
Contact the dealer.
