6
VENTILATION
WARNING:
Provide at least a 10ft
2
opening of fresh, outside air whilst running this
heater. If proper fresh, outside air ventilation is not provided, carbon
monoxide poisoning can occur.
INSTALLATION
Read these instructions carefully. Do not allow anyone who has not read these
instructions to light, adjust or operate this heater.
Do not attempt to operate the heater with any gas other than propane
This heater, including hose and regulator assembly, must be inspected before
each use and at least annually by a qualified service person. If the hose shows
evidence of excessive abrasion or wear or if the hose is cut, it must be replaced
prior to the heater being put into operation. The replacement hose assembly
shall be that specified by Clarke International.
Positioning the Heater
The heater and propane gas cylinder must be located on a hard, flat, level
surface to minimize the risk of accidental tipping. The propane gas cylinder should
be adequately restrained to prevent accidental tipping.
DO NOT operate this
heater with the supply cylinder in any other than the upright position.
This appliance must be located only in places where the potential for physical
damage to the appliance, or to individuals (burns), is reduced to a minimum.
This appliance produces radiant heat. Therefore, it must be located at least 6
feet away from any propane gas cylinder and must not be directed toward any
gas container within 20 feet.
The heater must be located such that it will not be exposed directly to water
spray, rain and/or dripping water.
Use of this heater in a draft/windy area decreases its efficiency. If possible, operate
the unit in a draft free area.
