Clarke Encore L20, Operator'S Manual, Page: 54 / 60

Ref # Part No. Description Qty.
1 Screw, ¼-20 -
2 Washer, ¼ Lock -
3 52660A Coupler 1
4 45044A Motor 1
5 69189A Transaxle Gearbox Assembly 1
6 Pin, Dowel -
7 End Plate, Output -
8 Magnet and Housing Assembly -
9 Armature and Bearing Assembly -
10 Washer, #10 Lock -
11 Nut 10-32 -
12 Stud -
13 52940A Commutator End Bell & Brush Asm. 1
14 51202A Mount, Bushing 2
Torque #1 80 inch pounds
Torque #11 40-45 inch pound tooth nuts
#12 Loctite #262
NOTE : Transaxle unit is sealed. No lubrication required
CLARKE TECHNOLOGY Encore L20
Transaxle Repair Parts 4/01
1
2
3
4
5
(COUPLER)
6
7
8
9
10
11
12
3.06 dia.
13
Commutator Endbell and
Brush Assembly
Installation Instructions:
1. With motor still fastened to transaxle gearbox,
remove old endbell by backing off the two 10-
32 nuts and removing the lock washers. Slide
endbell off motor.
2. Assemble new commutator endbell and brush
assembly by sliding it over shaft and motor
studs until brush retaining clip bottoms out.
Holding endbell still, slide retaining clip out from
between the brushes and commutator. Push
the endbell on the rest of the way until endbell
casting bottoms on the motor frame. Replace
the lock washers and nuts and torque the nuts
40-45 in.-lbs.
Page -54- CLARKE TECHNOLOGY Operator's Manual -Encore S20/L20
14
14