Clarke Devil 1250(ss), Operating & Maintenance Manual

Page: 10 / 28

10
STOPPING PROCEDURE
1. Turn OFF the gas at the cylinder valve.
2. Disconnect the gas supply.
3. Allow the fan to run for 2 - 3 minutes with the burner off, in order to allow
the casing to cool down.
4. Switch OFF the fan and disconnect the electrical supply.
MAINTENANCE
It is essential that the heater is correctly maintained and kept in top condition
at all times.
IMPORTANT Before carrying out any adjustment or maintenance, ensure the
heater is switched OFF, disconnected from the mains and gas supply, and
has been given adequate time to cool down.
All models are similar, in that access to the working parts, is gained by
removing the rear panel, which is secured by 4 screws, (3 in the case of the
Little Devil), around its edge. Once removed, the panel, complete with all
components, may be lifted clear.
MONTHLY (WHEN IN CONSTANT USE)
Ensure the electrode is clean and the gap is no more than 5mm.
Check the condition of the gas hose. If there are any signs of deterioration, it
should be renewed using only a CLARKE original spare part.
Ensure that all connections are clean and secure.
When necessary, clean the fan and the inside of the heater thoroughly.
IMPORTANT: The use of parts other than genuine CLARKE replacement parts
may result in safety hazards, decreased performance, and will invalidate
your warranty.
ENVIRONMENTAL PROTECTION
These products contain valuable raw materials. Do not dispose of this
product with general household waste. All tools, accessories and
packaging should be sorted and disposed off appropriately by taking
to a recycling centre.