4
OPERATION
Ensure the load is chocked and stable and on firm level ground
1. Position the jack so that the saddle is directly beneath the lifting point and
that there are no obstacles to prevent a clean lift, also, make sure that all
personnel are well away from the area, before raising the vehicle.
• Consult the vehicle handbook to determine the correct lifting points.
USING THE TROLLEY JACK
2. Place the two parts of the handle
together and secure together using the
10 mm bolt provided. Insert the handle
into position and secure using the small
bolt and washer on the rear of the handle
port.
3.
Bolt
Handle Port
Turn the handle, fully clockwise to close
the release valve and pump the handle
up and down to raise the saddle,
• As it meets the lifting point, make sure
that the saddle is in full contact and
that there are no obstacles to prevent
a clean lift.
4. Place axle stands or suitable supports
beneath the vehicle, before VERY GENTLY turning the handle
anticlockwise.
• This action will open the release valve to lower the load on to the
stands.
5. DO NOT jerk the handle, ensure it lowers slowly and under complete
control on to the axle stands which must be correctly positioned and take
the weight evenly.
• Ensure the axle stands are centred about the support point and
perfectly stable before full weight is taken.
NOTE:
Ensure this operation is carried out under complete control. DO
NOT allow the load to drop suddenly as this could damage
internal components.
6. Remove the jack from the vehicle.
NOTE:
The jack may move slightly during operation. It is important
therefore that the immediate vicinity is clean and completely
free from debris.
Summary of Contents for CTJ2001G
Page 8: ......
