4
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
UNPACKING AND ASSEMBLY
1. Remove the retaining clip , by
pressing the handle mounting
downwards and releasing the clip
from the base of the jack and
from the handle opening.
2. Undo the thumbscrew until the
lower handle can be inserted fully
into the handle socket.
•
The handle has a groove which
should engage with the thumb
screw once it is re-tightened.
3. Re-tighten the thumb screw to
secure the lower handle.
4. Add the upper handle by pushing
it onto the lower handle until the
ball and socket of the handle
sections snap together.
OPERATION
Before use, visually inspect the jack for oil leaks or any other sign of damage.
Should any be apparent, have the jack inspected and repaired by a
qualified technician before use.
Ensure the vehicle to be raised is chocked and standing on firm, level ground
before manoeuvring the jack so that the saddle is directly beneath the lifting
point. Consult the vehicle handbook to determine the suitable lifting points.
USING THE JACK
1. Turn the handle fully clockwise to close the release valve, and pump the
handle to raise the saddle until it reaches the vehicle lifting point.
2. Ensure that the saddle is directly below the lifting point and there are no
obstructions to prevent a clean lift. Keep all personnel at a safe distance
before continuing to pump the handle to raise the vehicle.
NOTE: The jack may move slightly during operation. It is important
therefore, that the floor is clean and completely free from debris.
Thumb
Screw
Groove
Retaining
Clip
Spring-loaded Ball
Socket
Handle
Mounting
Summary of Contents for CTJ2000A
Page 12: ......
