Clarke CRD620, Operating & Maintenance Instructions, Page: 10 / 15

-10-
Accessories
A = Accessory box.
B = Depth stop Rod
C = 8mm Tungsten Carbide Tipped
SDS Drill.
D = 10mm Tungsten Carbide Tipped
SDS Drill.
E = 12mm Tungsten Carbide Tipped
SDS Drill.
F = Pointed Chisel.
G = 22mm Chisel.
H = Wrench.
I = Dust Collector.
J = Grease.
A wide range of accessories is available from your nearest CLARKE dealer, for further
information, contact your nearest dealer, or telephone CLARKE International Sales
department on 01992 565300.
Maintenance
•
Ensure the tool is isolated from the electrical supply, by switching OFF and removing
the plug from the 13amp socket, before commencing any maintenance activities or
adjustments etc.
•
Clean the tool regularly, using a soft brush and or soft cleaning cloth, DO NOT use any
chemicals or harsh abrasives to clean the tool.
•
Remove and inspect the motor brushes on a regular basis, it is very important to refit
the motor bushes exactly as they are removed, DO NOT turn them round or swop their
positions.
Note: Dirty or worn motor brushes results in excessive sparking and loss of power etc.
•
Always replace motor brushes in pairs.
•
Check gearbox regularly and top up if necessary with a good quality high melting
point gearbox grease. DO NOT overfill the gearbox, apply sufficient grease to cover all
visible moving parts only.