3
GENERAL SAFETY RULES
1.
Read this instruction manual before connecting the sandblaster to a compressor.
2.
Safety glasses, hood, long-sleeve shirt, gloves and a respirator must be worn during
operation and clean up.
3.
During operation, do not expose the hands or skin to the blasted material, keep
hands away from the nozzle.
4.
Everyone in the blasting area must also wear personal protective equipment.
5.
Check the condition of hoses and air lines before each use.
6.
Make sure all connections are secure before use.
7.
Abrasives used in this unit may be covered by COSHH Regulations.
8.
ALWAYS make sure there is adequate ventilation. Do not spray in confined areas.
9.
ALWAYS disconnect the gun from the air supply when the sandblaster is not in use.
10. ALWAYS clean the gun thoroughly after use. See ‘Maintenance’
11. ALWAYS turn off the compressor and expel all air from the air hose and gun before
disconnecting the sandblasting gun.
12. ALWAYS use appropriate air hoses and couplings and ensure that they are in good
condition. If any parts are worn or damaged, they should be replaced immediately.
13. ALWAYS hold the tool firmly and maintain good balance.
14. NEVER carry the gun by the hose. Keep hoses away from heat, oil and sharp edges.
15. NEVER use wet or even damp grit. Ensure the grit is completely dry,
16. In the case of injury seek expert medical advice immediately.
17. NEVER allow unauthorised persons or children use or play with the sandblaster.
18. Do not use the sandblaster around animals.
Warning: Compressed air can be dangerous. Ensure that you are
thoroughly familiar with all precautions relating to the use of
compressors and compressed air supplies.
Warning: Disconnect the sandblaster from the air supply before
performing any maintenance.
Warning: Do not point the sandblaster gun at anyone or objects other
than the intended work object.
Summary of Contents for CPSB1
Page 7: ...7 NOTES ...
Page 8: ......
