SAFETY PRECAUTIONS
1.
ALWAYS
keep the unit perfectly clean. This will not only prolong its life, but will
also ensure you get the best results.
2.
NEVER
exceed an air pressure supply of 3bar (43.5psi) to the product.
3.
NEVER
attempt to adjust the safety valve
4.
NEVER
tamper with the product or modify in any way, as this could prove to
be dangerous and will invalidate the guarantee.
5.
ONLY
use the product for the purpose for which it is intended,
6.
ALWAYS
wear approved impact resistant SAFETY GOGGLES. (Eye glasses are
NOT safety glasses), and a FACE MASK
7.
DO NOT
remove any labels. Damaged labels should be replaced.
AIR SUPPLY
WARNING
Compressed air can be dangerous.
Ensure that you are thoroughly
familiar with all precautions relating
to the use of compressors and
compressed air supply.
Air pressure supply to the container should not be greater than 80psi. Higher pressure and
unclean air, will shorten the tools’ life because of faster wear, and could be a safety hazard.
Water in the air line will also cause damage. Ensure it is properly maintained at all times.
The recommended procedure to connect this product to an air supply, is shown below. A
filter/regulator should always be placed in line with the supply and the paint pot.
The air inlet used for connecting air supply, has a standard ¼” BSP thread.
Line pressure, or hose inside diameter, should be increased to compensate for unusually
long air hoses (over 10m). Minimum hose diameter should be 6mm (¼") ID., and fittings
should have the same inside dimensions.
3
Summary of Contents for CPP11
Page 8: ...Parts Diagram CPP 11 8...
Page 10: ...Parts Diagram CPP 30 40 10...
