8
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
BEFORE USE
WARNING: ENSURE THAT THE TOOL IS SWITCHED OFF AND UNPLUGGED
FROM THE MAINS SUPPLY BEFORE FITTING OR REMOVING THE ‘D’
HANDLE OR BACKING PAD.
FITTING THE ‘D’ HANDLE
1. Slot the ‘D’ handle onto the body
of the tool, locating the lugs into
the recesses in the tool body.
NOTE:
the handle is recessed to fit
onto the tool in one position only, and
is not adjustable, other than for left or
right handed use.
2. When the handle is in position,
secure in position with two allen
screws, supplied, tighten using
6 mm Hex key, DO NOT
overtighten.
FITTING THE BACKING PAD
1. Screw the backing disc onto the
spindle.
2. Press and hold the spindle lock
button and tighten the pad hand
tight in a clockwise direction.
• Either the polishing bonnet or a
sanding disc can be fitted.
IMPORTANT:
never press the spindle
lock button while the motor is
running. Failure to observe this
instruction may cause internal damage or could lead to personal injury.
