9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
INSERTING A DRILL BIT / CHISEL
The chuck clamps SDS drill bits and chisels without the need for a chuck key.
1. Pull back the collar and Insert the
bit.
• Turn the bit in the chuck until it
latches.
2. Release the collar to lock in
place.
3. Check by pulling the bit to see if it
is locked in place.
IMPORTANT: Always clean the shaft
of the drill bit before inserting into the chuck.
IMPORTANT: Do not allow dust or debris inside the chuck as this will cause
problems in the future.
REMOVING A BIT
1. Slide the collar to the rear and pull the bit out the chuck.
CAUTION: WHEN REMOVING A BIT FROM THE DRILL, REMEMBER THAT IT
MAY BE EXTREMELY HOT. EITHER ALLOW IT TO COOL DOWN FIRST OR USE
INDUSTRIAL GLOVES TO REMOVE THE BIT.
Summary of Contents for Contractor CON1500RDV
Page 20: ......
