6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SETTING UP THE SHARPENER
This sharpener should only be used on a stable, horizontal surface. It is
intended to be screwed down onto a workbench using the mounting holes in
the base. Use 4 x 1” No 8 counter-sunk screws (not supplied).
The sharpener is fitted with an interlock which prevents the motor from starting
unless one of the sharpening attachments is clipped into its operating position
on the power unit.
To attach each sharpening
attachment, slide it fully down the
slots on the front of the power unit
until it latches into place.
To release any sharpening
attachment, unclip it by pressing the
release catch down. Always wait for
the grinding wheel to stop before
removing the attachment. Store all
the attachments on sides of the
power unit when not in use.
Plug the sharpener into a suitable mains power outlet.
HIGH-SPEED DRILL SHARPENER
Using this attachment, you can sharpen any high speed drill bits from 7/64”
(3mm) to 3/8”(10mm). The sharpener holds the drill bit at the correct
sharpening angle.
Do not use with masonry or hammer drill bits.
SHARPENING PROCEDURE
1. Slide the drill sharpening
attachment onto the front of the
power unit and clip into place.
Summary of Contents for CMPS2
Page 16: ......
