SETUP AND OPERATION
•
Loosen the slide clamp screw.
•
Press the ON button to switch the calipers on, select the required measuring unit by pressing the inch/mm mode switch.
•
Apply pressure to the thumb roller and close the caliper jaws, press the ‘ZERO’ button to zero the display.
MEASURING APPLICATIONS:
Measurement of
external diameter.
Measurement of
internal diameter.
Measurement
of steps.
Measurement
of depth.
GENERAL VIEW
BATTERY REPLACEMENT
When the display constantly flashes the battery requires
replacement. Slide off the battery compartment cover
and insert a new battery with the positive (+) side
facing up.
For spare parts and servicing, please contact your nearest dealer, or CLARKE International on:
020 8988 7400 or email: [email protected]
CLARKE International, Hemnall Street, Epping, Essex, CM16 4LG
Low battery - Replace battery.
Electronic fault - Remove battery & re-insert after 30 seconds.
Battery flat or in poor contact - Re-insert or replace battery.
Dirty sensor - Clean caliper thoroughly with compressed air.
LCD Display
Inside Measuring Faces
Depth Measuring Blade
Step Measuring Faces
Beam
Main Scale
Battery Compartment Cover
Manufacturer Access Cover (Keep Closed)
Slide Clamp Screw
Thumb Roller
Power OFF Switch
ON / Display ‘Zero’ Switch
Inch / mm Mode Switch
Outside Measuring Faces
TROUBLE SHOOTING
:
FAULT:
CAUSE/SOLUTION:
Display flashes constantly.
Display fails to change when slider is moved.
Display fails to function.
Measuring becomes less accurate.