SAFETY PRECAUTIONS
•
Please read all the instructions in this manual and ensure they are completely
understood before using the hub separator. Failure to do so may result in
damage to the tool, vehicle hub or injury to the operator.
•
Use the tool
ONLY
for its intended purpose.
•
Ensure the vehicle to be worked on is secure from sudden movement by
applying the hand brake, placing it in “park” or securing it with chocks.
•
Ensure the space needed for use and maintenance of the tool is adequate
and free from debris.
•
Always wear approved eye protection when working with the hub separator.
A
full range of personal safety equipment is available from your CLARKE dealer.
•
The tool must not be modified in any way.
•
Use only the recommended accessories and original spare parts for the tool.
Improper accessories can be hazardous.
•
NEVER wear loose or ill fitting clothing to avoid snagging.
•
Remove watches, rings and other jewellery before operating. Tie back long
hair.
•
ALWAYS secure the work area when finished. Account for all tools and parts
used and do not leave them near the work area.
UNPACKING AND PREPARING FOR USE
Unpack the carton and check that the following items are included.
A.
Yoke Assembly
B.
Adjusting Screw
C. Adjusting Screw Nut
D.
Forcing Screw Assembly
E.
Bolt/nut M12x50 (x2)
F.
Bolt/nut 7/16”x2-3/4”
G.
Bolt/nut M12x110
H.
Saab Adaptor
I.
Adaptor Plate
J.
Set Screw M10x25 (x2)
K.
Set Screw M12x25
L.
Honda Adaptor Plate (x2)
M.
Adaptor Tube
1.
Mount the adaptor plate (I) onto the lower ball joint.
2.
Place the forcing screw assembly (D) in the centre of the hub and
lower the yoke assembly (A) down onto the hub. Fit the adjusting screw
nut (C) to the adjusting screw.
3.
Mount the yoke assembly (A) to the strut leg mount (3) using the bolt/
nut (F).
4.
Turn both forcing screw (D) and adjusting screw (C), until the yoke (A)
is parallel with the disc/hub and the forcing screw (D) is perpendicular
to the disc/hub.
Once this is accomplished, begin the turn the forcing screw to separate
the hub, paying close attention to the notes on page 4 regarding
excessive force
FOR USE WITH
MOST TOYOTA
AND SIMILAR HUB TYPES
6
3
