11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ATTACHING THE CHAIN BAR AND CHAIN
1. Place the chainsaw on a stable
surface.
2. Loosen the cover locking screw
and remove the housing cover.
3. Slide the bar into place so that the
tensioning wheel slides over the
bolt as shown.
• The locating pin slides into the
channel shown.
4. Put the chain onto the bar.
• The chain bar is marked with an
arrow, showing the direction in
which the chain will travel.
5. Make sure all the chain links are
seated correctly into the groove
on the chain bar
• The cutting teeth on the upper
side of the bar must point
forward.
6. Put the free end of the chain over the drive sprocket
• If the chain does not reach, turn the tension wheel anticlockwise.
7. To secure the bar, replace the housing cover and tighten the cover locking
screw finger tight.
8. Adjust the blade tension as follows.
Summary of Contents for CECS405C
Page 28: ......