6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE AXLE STANDS
1. Refer to the vehicle handbook for the correct jacking procedure and
location of the support points.
2. Raise the vehicle using a suitable lifting jack.
ADJUST THE AXLE STAND
3. Raise the saddle on the axle stand to the required height.
•
Make sure the ratchet mechanism is fully engaged
.
4. Position the axle stand under a suitable supporting point. See your vehicle
manual for the location.
LOWERING THE VEHICLE
1. Slowly lower the vehicle onto the centre of the saddle.
TO REMOVE THE AXLE STANDS
1. Raise vehicle clear of the axle stands.
2. Remove stands.
3. Ensure that all tools, equipment and personnel are clear before carefully
lowering the vehicle to the ground.
WARNING: BEFORE USE, MAKE SURE THAT THERE IS NO DAMAGE TO ANY
PART OF THE AXLE STAND, IF THERE IS, DO NOT USE.
WARNING: DO NOT EXCEED THE RATED LOAD OF 3000 KG PER PAIR OR
1500 KG PER STAND.
WARNING: USE ONLY ON A HARD, FLAT SURFACE, E.G. CONCRETE.
WARNING: DO NOT LOAD THE STANDS OFF CENTRE. FAILURE TO HEED THIS
WARNING MAY CAUSE DAMAGE, INJURY OR LOSS OF LIFE.
CAX3TBC 3 Tonne folding axle stand.fm Page 6 Thursday, February 11, 2016 11:22 AM
