2
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
INTRODUCTION
Thank you for purchasing this CLARKE Blow Gun kit.
Before attempting to use this product, please read this manual thoroughly and
follow the instructions carefully. In doing so you will ensure the safety of yourself
and that of others around you, and you can look forward to your purchase
giving you long and satisfactory service.
Please keep these instructions in a safe place for future reference.
SPECIFICATION
COMPRESSED AIR REQUIREMENTS
Use only clean, dry, regulated compressed air as a power source.
A build-up of moisture or oil in the air compressor will accelerate wear and
corrosion in the tool. Ensure any moisture is drained from the compressor daily
and the inlet filter is kept clean.
If an unusually long air hose is required, (over 8 metres), the line pressure or the
hose inside diameter may need to be increased.
The hose must be rated at 150% of the max operating pressure of the tool.
If an automatic in-line filter/regulator is used, it will keep the tool in good
condition, but should be regularly checked.
Never exceed the maximum operating pressure for the air tool. It is
recommended that air pressure to this tool does not exceed 90 psi. Higher
pressures and dirty air will shorten the life of the tool due to faster wear and is a
possible safety hazard
Max Operating Pressure
90 psi (6.2 bar)
Air Inlet Size
1/4“BSP Female
Air Consumption
9.5 cfm (max @90psi)
Dimensions
Pocket Blow Gun - 97 x 20 x 29mm (0.057kg)
Short nozzle Blow Gun - 130 x 140 x 21mm (0.13kg)
Long nozzle Blow Gun - 240 x 17 x 87mm (0.085kg)
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF
COMPRESSORS AND COMPRESSED AIR SUPPLY.
Summary of Contents for CAT211
Page 8: ......
