5
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
15. DO NOT carry out any alterations or modifications to the blow gun.
16. Always disconnect from the air supply when performing any maintenance.
17. DO NOT use an air tool if it is defective or operating abnormally.
18. ALWAYS maintain an air tool with care. Keep it clean for the best and safest
performance.
19. DO NOT carry the blow gun by the air hose or with your finger on the
trigger.
20. When not in use the blow gun must be disconnected from the air supply
and stored in a dry place out of the reach of children.
BEFORE USE
CONNECTING THE AIRLINE
Ensure the air supply is isolated from
the airline at a shut-off valve.
1. Connect a suitable hose to the air
inlet connector as shown.
2. Connect the other end of the air
hose to the air compressor.
3. Set the compressed air pressure to
suit the task at the airline regulator.
4. Turn on the air supply and check
for air leaks. Rectify any found before proceeding.
• PTFE tape may be useful for sealing threaded connections.
5. Your blow gun is now ready for use.
• You can fit a whip hose with a quick fit coupling if required, available
from your CLARKE dealer.
DISCONNECTING THE AIR SUPPLY
1. DO NOT disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose from
the blow gun.
3. Shut down the compressor at the end of the work session.
Summary of Contents for CAT209
Page 8: ......
