6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CLEANING
1. Clean the plastic bowl with warm water only. Clean other parts with warm
water and soap.
2. Rinse and dry all parts. Blow out internal passages in the body with clean,
dry, compressed air.
3. Inspect all parts and replace any found to be damaged.
ASSEMBLY
1. Lubricate o-rings, the portion of the manual drain body that contacts the
bowl and the hole in the manual drain body that accommodates the stem
of drain valve with o-ring grease.
2. Assemble as shown on page 7 using the torque values listed in the table.
3. Push the bowl into the body and turn fully clockwise.
ACCESSORIES
A wide range of accessories is available including filter/regulators, lubricators,
high-pressure hoses (5 to 50 metres) etc. Contact your CLARKE dealer for
further information or CLARKE International Service Department.
Torque Settings
Part
Inch Pounds (N-m)
Screw (a)
15 to 20 (1.7 to 2.3)
Screw (b)
6 to 8 (1.1 to 1.6)
Fill plug
9 to 11 (1.0 to 1.2)
Dome
20 to 25 (2.3 to 2.8)
Summary of Contents for CAT195
Page 8: ......
