Clarke 7640117, Operation & Maintenance Instructions Manual

Page: 3 / 12

3
GENERAL SAFETY RULES
1. Read this instruction manual before connecting this device to the
compressor.
2. Do not use any silica based abrasives with this sandblaster. Silica based
abrasives have been linked to severe respiratory disease. Always use
recommended abrasives. Abrasives used in this sandblaster may be
covered by COSHH Regulations.
3. Safety glasses, hood, long-sleeve shirt, gloves and a NIOSH/MSHA
approved respirator must be worn during operation and clean up.
4. During operation, do not expose the hands or skin directly in the line of the
Sandblasting Gun nozzle.
5. After assembly, inspect to make sure all components seal properly.
6. Everyone in the blasting area must also wear protective gear.
7. Check hoses and air lines for weak or worn condition before each
use.Make sure all connections are secure before use.
8. Products used in this unit may be covered by COSHH Regulations.
9. ALWAYS make sure there is adequate ventilation. Do not spray in confined
or enclosed areas.
10. ALWAYS disconnect the gun from the air supply when it is not in use, and
before any disassembly.
11. ALWAYS thoroughly clean the gun after use. See ‘Maintenance’
12. ALWAYS turn OFF the air supply at the compressor outlet, and expel all air
from the air hose and gun, BEFORE disconnecting the Sandblasting Gun
from the air hose.
Warning: Compressed air can be dangerous. Ensure that you are
thoroughly familiar with all precautions relating to the use of
compressors and compressed air supply.
Warning: Disconnect the abrasive blaster from the air supply before
changing accessories or attempting to install, service, relocate or
perform any maintenance.
Warning: Do not point the abrasive blaster gun at anyone or objects
other than the intended work object.