Clarke 7613020, Operation & Maintenance Instructions Manual, Page: 10 / 16

10
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
• Check the hydraulic connections for leaks. Replace or properly repair any
damaged or leaking hydraulic components before using. In the event of
leaking seals, oil can be topped up via the plug on the end of the pump. Oil
should be level with the bottom of the hole. If necessary top up with CLARKE
hydraulic oil, Part No. 3050830.
This task is carried out with the ram fully
retracted.
• If any rust is apparent it must be removed completely and the paint restored.
DE-COMMISSIONING PRODUCT
Should the product become completely unserviceable and require disposal,
draw off the oil into an approved container and dispose of the product and
the oil according to local regulations.
TROUBLESHOOTING
ACCESSORIES
7-piece mandrell (adaptor) kit for CSA12F Press: part no 7615060.
(Also listed as items 14 & 34 -39 on the parts list (pages 12 & 13).
Problem Probable Cause Remedy
Pump unit will not work Dirt on valve seat/warn
seals Bleed pump unit or have
unit overhauled with new
seals
Pump will not produce
pressure
Pump feels hesitant
under load
Pump will not lower
completely Air-lock Open the release valve
and remove the oil filler
plug. Pump the handle a
couple of full strokes and
close the release valve.
Replace the filler plug.
Pump will not deliver
pressure Reservoir could be over-
filled or have low oil level. Check oil level by
removing the filler plug
and topping up to the
correct level.
Pump feels hesitant
under load Pump cup seal could be
worn out. Have the cup seal
replaced.
Pump will not lower
completely Air-lock Release air by removing
the filler plug