8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
USING THE REMOTE CONTROL
All operations must be done using the
remote control.
• 2 x AAA batteries are required
and are installed as shown by
the diagram found inside the
control unit.
• The remote control must be
directed at the heater display
panel. It has a range of approx
2.5 metres and must be aimed
at the correct angle.
MANUAL OPERATION
1. Position the heater where required,
and lock the castors to prevent the
heater from moving. Always move
the heater using the handles.
2. Slacken the locking knobs and
rotate the heater body to the
required angle. Tighten the
securing knobs on each side to
lock into place.
3. Connect the power cable to a
suitable power supply.
• The heater is equipped with an
anti-tilt switch that
automatically cuts the power off should the heater tip over. If this
happens, stand the heater upright and it will immediately re-set.
WARNING: FOR SAFE OPERATION OF THIS HEATER IT IS ESSENTIAL TO READ
THESE INSTRUCTIONS BEFORE USE.
Summary of Contents for 6926018
Page 16: ......
