26
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ADJUSTING THE SHEAR TABLE.
TO ADJUST THE BLADE GAP BY MOVING THE TABLE:
1. Loosen the cap screws on either
end of the shear table that secure
it to the machine (see Figure 44).
2. Evenly rotate the table
adjustment screws to adjust the
position of the shearing table until
the blade gap is even, then re-
tighten the cap screws to secure
the table in place.
NOTE:
Rotating the table
adjustment screws clockwise moves the table toward the upper
shear blade.
3. Perform the previous shear test.
4. If necessary, repeat Steps 1-3 until you are satisfied with the shear test cut.
ADJUSTING THE BLADE BOW
The adjustment bolt of the blade
bow is used to remove any slight bow
in the cast iron cross beam that the
brake finger receiver and upper
shear blade are attached to (see
Figure 45).
Tools Needed
Qty
Hex Wrench 6mm
1
Standard Screwdriver #2
1
Tools Needed
Qty
Wrench 14mm
2
Fig. 44
Fig. 45
Summary of Contents for 6560005
Page 36: ......
