10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
TORQUE ADJUSTMENT
To select the correct torque setting for screwdriving:
1. Set the mode adjustment collar to
1.
2. Fit and tighten the first screw.
• If the clutch starts to ratchet
before the screw is correctly
seated, rotate the mode
selector to a higher number
until the clutch ratchets only
when the head of the screw is
flush with the surface of the
material.
OPERATING THE DRILL
1. Make sure that the forward/reverse switch is positioned in either the
forward, or reverse position. See page 8
NOTE:
The trigger will not operate if the direction control switch is in the
central position.
2. Squeeze the trigger.
• The drill will start.
• The speed can be increased by increasing the pressure on the
trigger up to the maximum speed (Setting 1 - 350 rpm, Setting 2 -
1250 rpm).
3. Release the trigger to stop the drill.
• The drill is fitted with an electric brake which stops the motor when
the trigger is released.
CAUTION: DO NOT ADJUST THE MODE SELECTOR WHILE THE CHUCK IS
ROTATING.
