7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BATTERY CHARGING
• The battery pack must be charged before operating the drill.
• The battery should be charged at ambient air temperatures of
between -10
o
C and 45
o
C.
To charge the battery pack, proceed as follows.
1. Connect the charger to the mains
supply.
• The green power indicator will
light up.
2. Slide the battery onto the battery
charger.
• The green power indicator will
stay on and the red charging
LED will start flashing while
charging is in progress.
• When the battery is fully
charged, both the red and
green LEDs will be on.
• If both LEDs are flashing rapidly
the battery pack has become too hot or is defective.
3. Switch off the charger at the mains and remove the battery.
NOTE:
Whilst charging, the battery pack and charger may become warm.
This is normal and can be expected.
WARNING: WHEN THE BATTERY IS REMOVED FROM THE DRILL AFTER USE, IT
MAY BE HOT. ALWAYS ALLOW IT TO COOL BEFORE RECHARGING. DO
NOT RECHARGE A HOT BATTERY.
Summary of Contents for 6479531
Page 16: ......
