Clarke 6462125, Operating & Maintenance Instructions

Page: 7 / 14

UNPACKING and PARTS IDENTIFICATION
ASSEMBLY and INSTALLATION
A - Planer
B - Fence complete
C - Dust Collection Bag
D - Hose Clip
E - 4mm Hex. Wrench
F - 5mm Flat Washer
G - 5mm Lock Washer
H - M5x15 Hex. Socket Head Bolt
J - Pushstick
Not Shown - Dust Extraction Port
Extension
Fig. 1
Fig. 2
Carefully unpack the components and lay them out, checking against the
following list. Should any part be missing or damaged in transit, please contact
your Clarke dealer immediately.
Ensure the planer is located where there is adequate light, and a suitable power
supply. If cable a extension is used, ensure it does not trail along the workshop
floor as this could be extremely hazardous.
There must be sufficient room for the workpiece to move through its entire length.
Similarly, there must be sufficient room so that the operator does NOT need to
stand in line with the wood during the planing process.
The planer may be used as a mobile unit, but for greater stability we recommend
it is bolted to a strong, firm workbench. The dimensions for the mounting holes are
shown below:
Alternatively, mount the planer on a strong piece of plywood of at least 15mm in
thickness, with length 550mm and width 330mm minimum. The plywood platform,
with planer mounted, is then clamped firmly to a workbench when required.
7