When the handle is in place, secure it in position
with two allen screws and tighten the screws
using an 8mm Allen key. DO NOT overtighten.
2
Side Handle Only
To use the side handle only, screw into the D
shaped boss on either side of the body,
depending whether the tool is to be used left or
right handed. See Fig. 3. DO NOT overtighten.
3
Both Handles
To fit both handles, Fit the ‘D’ Handle as
described in section 1.
Only fit one Allen screw to the longest side of the handle as shown in Fig. 4, DO NOT
tighten yet.
Secure the other side using the side
handle, hand tight only, tighten the Allen
screw as before.
NOTE: store the spare Allen
screw for use to secure the ‘D’
handle should it be necessary
to remove the side handle.
Fitting Backing Pads
To fit backing pads, depress the spindle
lock and screw the required backing
pad onto the spindle, hand tight only.
To remove the pads it may be necessary to use the spanner supplied.
IMPORTANT
never depress the spindle lock whilst the motor is running. Failure to observe
this instruction may cause damage to the tool and could even lead to personal injury.
Depending on which pad is fitted, either the polishing bonnet or sanding discs can be
fitted.
When fitting the bonnet ensure the lace tails are tucked away before switching the
polisher on.
Fig. 3
Fig. 4
Allen Screw
-6-