11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
GENERAL CARE
Your sander has been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation depends upon
proper care.
• Regularly clean the ventilation slots using a soft dry brush or dry cloth.
• Only clean the motor housing using a clean damp cloth. Do not use any
abrasive or solvent-based cleaner.
• A damaged power cable should be replaced by your Clarke dealer or
a qualified electrician.
• The bearings in this sander are sealed for life and require no
maintenance.
TROUBLE SHOOTING
SANDER IS OVERHEATING
This indicates the machine is dirty. Clean the ventilation holes, and blow out
with compressed air or clean with a dry cloth.
Overloading the machine will also cause overheating. Do not apply excessive
pressure.
EXCESSIVE SPARKING OCCURS
This indicates worn brushes. This problem is quickly remedied but you should
consult your CLARKE dealer for parts and advice.
SANDER DOES NOT OPERATE WHEN SWITCHED ON
Check to ensure the fuse is sound and replace if necessary. If the fuse is sound
or blows repeatedly, consult your CLARKE dealer.
THE DUST IS NOT EXTRACTED
Dust bag is full (empty waste bag), dust extractor flue is blocked, this is usually
caused by allowing bag to become too full, (remove and empty bag, also
clear blockage).
ACCESSORIES
A wide range of accessories is available from your nearest CLARKE dealer, for
further information, contact your nearest dealer, or telephone CLARKE
International Sales department on 01992 565300.
Summary of Contents for 6462080
Page 16: ......
