22
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
90 DEGREE STOP ADJUSTMENT
4. Put a set square on the table and
up against the blade.
NOTE:
Do not touch the tips of the
blade teeth with the square.
If adjustment is necessary, continue
as follows:
5. Loosen the lock nut and turn the
90° adjustment stop screw in or
out until the blade is at 90° to the
table as shown by the set square.
6. If the bevel pointer does not point
to zero on the bevel scale, loosen
the screw that secures the bevel
pointer and move the pointer as
necessary.
45 DEGREE STOP ADJUSTMENT
1. Loosen the bevel adjustment
handle and set the saw head as
far to the left as possible (this
should be the 45° angle)
2. Put a 45° set square on the table
and up against the blade.
NOTE:
Do not touch the tips of the
blade teeth with the square.
3. Loosen the lock nut and turn the
45° adjustment stop screw in or out until the blade is at 45° to the table as
measured with the square.
4. Adjust the bevel pointer if necessary as shown in point 6 above.
TRANSPORTING
1. Lower the head and lock it down using the head lock pin.
2. Slide the head towards you and secure in position using the slide rail lock.
3. Lock the mitre arm with the table mitre lock.
4. Lock the bevel adjustment handle with the saw head in the vertical
position to make the tool as compact as possible.
5. Always lift the saw using the table.
Summary of Contents for 6461515
Page 32: ......
