Clarke 6460200, Operating & Maintenance Instructions

Page: 9 / 16

3.2 Undo and remove the two screws securing
the Keep Plate, arrowed in Fig.5.
Fig. 5
3.3 Replace the parallel Fence with the Roller
Guide, in the manner shown in Fig.6, ensuring
it slides neatly and freely on the base.
Fig. 6
3.4 The roller follows either a template, or the
edge of the workpiece, as shown in Fig.7.
Fig. 7
Setting Depth Of Cut for Plunge Routing
With the appropriate cutter installed, noting that plunge cutters and combination plunge
and side cutters are available, proceed as follows:
ADJUSTMENTS
Lock nut
Adjuster
Rod
Multi
Stop
Turret
Fig. 7
1. Release the plunge locking Lever (see Fig. 1) to allow
the main body to rise to its fullest extent.
NOTE: The main body is fully extended, when there is no
load on the microadjuster. Turn the microadjuster
anticlockwise so that when the main body is fully
extended, the adjuster may be easily turned clockwise
AND anticlockwise.
2. If necessary, raise the scale (simply loosen the depth
stop lock knob in order to pull it upwards) so that
the adjuster rod, see Fig.7, is clear of the multi stop
turret, then turn the turret to the highest position
directly beneath the adjuster rod.
3. With the router resting on the workpiece, pull
back the plunge locking lever and gently
plunge the router until the cutter just touches
the work surface, ensuring the adjuster rod does
not make contact with the turret. Release the
plunge locking lever to lock it in place.
9