5
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
• Before further use of the tool, it should be carefully checked to
determine that it will operate properly and perform its intended
function.
• Check for alignment of moving parts, binding of moving parts,
breakage of parts, mounting and any other conditions that may affect
its operation.
• A guard or other part that is damaged should be properly repaired or
replaced by a CLARKE service centre.
• Have defective switches replaced by a CLARKE service centre.
•
DO NOT
use the tool if the switch does not turn it on and off.
19. WARNING
• The use of any accessory or attachment other than one recommended
in this instruction manual may present a risk of personal injury.
20. Have your tool repaired by a CLARKE service centre.
• This electric tool complies with the relevant safety rules. Repairs should
only be carried out by qualified persons using original spare parts,
otherwise this may result in considerable danger to the user.
ADDITIONAL
1. Position the fence on the lower side of the table when bevel-cutting with
the table inclined;
2. Use a suitable holding device when cutting round or irregular shaped
timber to prevent twisting of the work piece;
3.
DO NOT
use saw blades which are damaged or deformed;
4.
DO NOT
override the lockout and operate the tool, when the guards
protecting the saw blade is open;
5.
DO NOT
clean the saw blade whilst it is moving;
6.
ALWAYS
wear gloves for handling the saw blade and rough material.
7. The push-stick should be used if the distance between the blade and rip
fence is less than approx 150 mm.
Summary of Contents for 6460141
Page 32: ......
