14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
REPAIR FUNCTION
Press the
FUNCTION
button until the
REPAIR LED
is lit to enter this mode (digital
display shows
REPAIR-ON
). It is an advanced battery recovery mode for
repairing old, idle, stratified or sulfated batteries. Not all batteries can be
recovered. For optimal results, take the battery through a full charge cycle,
bringing the battery to full charge, before using this mode. This mode uses a
high charging voltage and may cause some water loss in WET cell batteries.
Some batteries and electronics may be sensitive to high charging voltages. To
minimise the risks, disconnect the battery from the vehicle before using this
mode. To stop repairing, press the
FUNCTION
button again and the
REPAIR LED
will turn off (digital display will show
REPAIR-OFF
).
ALTERNATOR CHECK
To check the alternator percentage, carry out the following steps:
1. Connect the charger to the battery following the instructions given on
page 10.
2. With the charger connected to the battery and chassis, press the
DISPLAY
button until the
ALTERNATOR%
is lit.
3. Start the vehicle and turn the vehicles headlights on. The percentage will
show on the display screen.
The alternator percentage range is from 0% to 100%. readings below 0% will read
LO and readings above 100% will read HI. If you get a HI or LO reading, have the
electrical system checked by a qualified technician.
Summary of Contents for 6261525
Page 24: ......
