10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SMART CABLE STATUS LIGHTS
JUMPSTART THE VEHICLE BATTERY
ALWAYS carry out the following preliminary checks:
• Switch off the vehicle ignition and ALL ancillary equipment (lighting,
radio etc.)
• Ensure the vehicle battery is rated at 12V and is not damaged in any
way.
• Ensure the area is well ventilated.
• Make sure that the device is at least 60% charged (3 power indicator
lights are lit).
NOTE:
This device will not jumpstart a vehicle if the battery is very low or
completely flat.
1. Switch the ignition to ‘start’
FOR A MAXIMUM OF 6 SECONDS)
. If the engine
does not start within this time, SWITCH OFF the ignition and
WAIT FOR AT
LEAST 3 MINUTES BEFORE TRYING AGAIN.
2. Once the engine is running, disconnect the clamps within 30 seconds,
BLACK clamp FIRST, then disconnect the RED clamp.
3. Leave the vehicle engine running for a while to let the alternator recharge
the battery.
STATUS
Green LED
Red LED
Beeping
Detecting
Flashing
Flashing
No
Ready to start
Solid
Off
No
Low Voltage
Off
Solid
No
High Voltage
Off
Solid
No
Short Circuit
Off
Flashing
Yes
Reverse Polarity
Off
Flashing
Yes
Reverse Charge
Solid
Solid
Yes
Over heating
Off
Solid
Yes
No operation within 30 seconds of connecting
to the battery terminals
Solid
Solid
No
CAUTION: MAKE SURE THAT AT LEAST 3 POWER INDICATOR LIGHTS ARE
LIT BEFORE YOU ATTEMPT TO JUMPSTART.
Summary of Contents for 6239005
Page 12: ......
