4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
11. ALWAYS set the forward/reverse Switch-bar to neutral when changing bits
or when the machine is not required for immediate use. This will avoid
accidental starting.
12. ALWAYS
check for any damage or any condition that could affect its
operation. Any damaged part should be properly repaired.
13. NEVER force or misuse the machine. It will do a better and safer job at the
rate for which it was designed.
14. NEVER use this product if it is defective / operating abnormally.
15. NEVER carry the machine with your finger on the trigger.
16. NEVER abuse the mains cable of the battery charger. Never yank the
cable to disconnect it from the socket. Keep the cable away from sharp
edges/hot surfaces.
17. NEVER over-reach. Keep proper footing and balance at all times.
18. NEVER use this product for any other purpose than that described in this
booklet.
19. NEVER carry out any alterations or modifications to this product.
20. NEVER attempt to wipe the machine clean with solvents. Wipe plastic parts
with a soft cloth, slightly dampened with soapy water.
21. NEVER attempt any repairs yourself. If you have a problem with this product
contact your local CLARKE dealer.
IMPACT WRENCH SAFETY INSTRUCTIONS
1. ALWAYS use the impact wrench in the manner and for the functions
described in these instructions.
2. ALWAYS ensure the machine is not moving with the switchbar in the centre
position when changing sockets etc. Use only Impact Wrench sockets....DO
NOT use standard sockets.
3. ALWAYS
finish tightening wheel nuts or engine parts with a torque wrench
or suitable spanner to the correct torque as recommended by the vehicle
manufacturer.
4. ALWAYS
avoid excessive use of the wrench. When tightening a nut or bolt,
never allow the wrench to impact more than 8 times - to avoid over
tightening - 3 to 4 impacts is normally sufficient.
5. ALWAYS
use outdoor extension leads if working outdoors. Always use an
approved cable extension suitable for the power rating of the battery
charger (see specifications), the conductor size should also be at least the
same size or larger than that on the charger. When using a cable reel,
always unwind the cable completely.
Please keep these instructions in a safe place for future reference.
Summary of Contents for 4500633
Page 16: ......
