10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
STEP 4: SQUARE AND ANCHOR THE FRAME
1. Check the measurements of the frame are 12’ at both the front and back
corners, as well as across the center.
2. Take a diagonal
measurement as shown in
Diagram F. When these two
measures are equal the
frame is square. Adjust the
frame until they are equal
to within 1".
3. Check the width
measurement again to
ensure all widths are equal
at 12'.
4. Next, install the anchors
(Parts #16, #17 & #18) at the
4 corner bent legs by screwing the removable anchor (#16) into the
ground on the inside of the frame.
5. Secure with cable (#17) and cable clamp (#18) (as shown in Diagram G).
• Ensure the clamps are gripping the cables securely.
WARNING: SERIOUS INJURY TO PERSONS OR PROPERTY COULD RESULT IF
THE GARAGE IS NOT SECURELY ANCHORED, WITH EITHER THE GROUND
ANCHORS SUPPLIED OR IF SITED ON CONCRETE OR TARMAC USE
SUITABLE SUBSTANTIAL GROUND ANCHOR BOLTS.
Summary of Contents for 3503576
Page 16: ......
