9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
SETTING THE DIRECTION OF ROTATION
To select the direction of rotation turn
the direction control as follows.
• For tightening bolts/nuts, turn
the direction control anti-
clockwise to F (Forward).
• For loosening bolts/nuts, turn the
direction control clockwise to R
(Reverse).
FITTING SOCKETS AND USING THE AIR RATCHET
IMPORTANT: Only use sockets designed for use with a ratchet wrench;-
either 3/8" (10mm) for the CAT109 or 1/2” (13mm) for the
CAT108.
1. Select the socket you require and
push it onto the square drive shaft.
• It clicks into place when secure.
2. Place the socket over the nut.
• Take care that the socket is
firmly engaged.
3. Squeeze the trigger against the
body of the tool to start.
4. Release the trigger to stop the tool.
5. ALWAYS ensure the tool has stopped before putting it down.
6. When releasing very tight fastenings initially break loose by hand. Squeeze
the trigger and the air tool will complete the job.
7. If necessary, use penetrating oil to assist in freeing off rusted fasteners.
8. When assembling, start turning fasteners by hand, then set the rotation
forward or reverse. Apply the tool gently and squeeze the trigger to tighten
with power.
WARNING: ALWAYS WAIT UNTIL THE DRIVE SHAFT HAS STOPPED ROTATING
BEFORE SETTING THE DIRECTION CONTROL.
Summary of Contents for 3120110
Page 16: ......
