9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
5. If necessary, adjust the stroke as
follows:
• Hold the rear jaw case (fig. 6)
with the larger spanner and
loosen the lock nut with the
spanner/gauge.
• Adjust the stroke by rotating the
jaw case assembly and tighten
the lock nut when adjustment is
complete.
6. Refit the frame head.
CHANGING JAWS
1. Disconnect the tool from the air
line.
2. Remove the frame head (fig. 7)
using the spanner provided.
3. Use both spanners to unscrew the
front jaw case (fig. 8) from the rear
jaw case.
4. Remove the jaws and clean with
solvent and brush. If the teeth are
blunted, replace with new jaws.
5. Reverse the above procedure to reassemble.
OPERATION
1. Select the nosepiece to suit the rivet size and fit to the frame head using
the spanner.
2. Insert the rivet stem fully through the nosepiece and thus into the jaws.
3. Press the rivet body through the pre-drilled hole and hold with the rivet
flange flush on the workpiece.
4. Squeeze the trigger. The rivet will be compressed and the rivet stem will be
ejected into the safety cap.
WARNING: ALWAYS FIT THE SAFETY CAP TO THE REAR OF THE FRAME
BEFORE USE TO PREVENT INJURY FROM EJECTED RIVET STEMS. FIT WITH THE
SLOT FACING DOWNWARDS SO THAT THE STEMS FALL TO THE FLOOR.
