10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
DISCONNECTING THE AIR SUPPLY
1. DO NOT disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose from
the air tool.
3. Shut down the compressor at the end of the work session and drain daily as
recommended.
STORAGE
When not in use, disconnect from the air supply, clean & store in a safe, dry
place.
If the tool is to be stored or is idle for longer than 24 hours, run a few drops of
CLARKE air line oil into the air inlet and run the tool for 5 seconds in order to
lubricate the internal parts. When storing, replace the blanking plug on the
airline inlet.
Avoid storing the tool where the temperature is below 0
o
C.
MAINTENANCE
DAILY
1. Before use, drain water from the compressed air supply.
2. If no line lubricator or mini oiler is used, ensure that oil is applied to the tool
on a daily basis through the air inlet connection. Run a few drops of oil
through the tool before use. It may be entered into the tool air inlet,
(ensuring the strainer is clear), or into the hose at the nearest connection to
the air supply.
3. This procedure should be repeated after every two to three hours of use or
at the start of the working day.
4. Keep the body of the tool clean and free from debris.
WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE
COMPRESSED AIR SUPPLY BEFORE STARTING ANY CLEANING OR
MAINTENANCE PROCEDURES.
Summary of Contents for 3110471
Page 16: ......
