11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
WEEKLY
1. If in regular use, check the air inlet
screen filter for blockage and
clean if necessary.
CLEANING
Grit or gum deposits in the tool may
reduce efficiency.
1. After extensive use, remove the
inlet screen filter and flush out the
mechanism with gum solvent oil or
an equal mixture of CLARKE air-line oil and paraffin. Allow to dry before
use.
2. If the tool still runs erratically or becomes inefficient and the air supply is of
good quality, it may be necessary to dismantle the air motor and replace
worn or damaged parts. You may prefer to take the tool to your CLARKE
dealer if internal maintenance is required.
HYDRAULIC SYSTEM LUBRICATION
1. Remove the oil plug with the hex
key (provided) and set aside.
2. Fill the reservoir with hydraulic oil.
Take care not to overfill.
3. Screw the oil plug back in and
clean any excess oil.
PERFORMANCE
Please note that outside factors may effect the operation and efficiency of
the tool, such as reduced compressor output, excessive drain on the airline,
moisture or restrictions in the air-line, or the use of connectors of improper size
or poor condition which will reduce air supply.
Your air tool has been designed to give long and trouble free service. If,
however, having followed the instructions in this booklet carefully, you
encounter problems, take the unit to your local CLARKE dealer.
Summary of Contents for 3110470
Page 16: ......
