CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700
Page -9 -
HOW TO CORRECT PROBLEMS IN THE MACHINE
The machine will not run.
The machine may not have
Make sure the machine is connected to
any power.
the correct voltage and frequency and
that all connections are tight or,
Make sure the machine is plugged in.
The power cord may be
damaged.
Contact an authorized service person
The pad is worn or dirty.
Clean the pad. If the pad is worn, replace it.
The main switch is defective.
Contact an authorized service person.
The circuit breaker is defective.
Contact an authorized service person.
The machine is noisy.
The motor is defective.
Return to service center.
The bearings are dry.
Grease the bearings or return to service
center.
The belt is slipping.
Re-tension the drive belt.
The brush warning light
The carbon brushes need
illuminates.
replacing.
Contact an authorized service person.
The machine is vibrating
The pad is not installed
Remove the pad. Install the pad correctly.
excessively.
correctly.
Center the pad properly.
The pad is worn or damaged.
Install a new pad.
Action
Cause