1
2
3
4
5
6
Remove the
Diluvio™
Loudspeaker from its box. Using a pair of wire cutters, carefully remove 1 inch (2.54
cm) of the sound lens rubber ring (see Photo #1 below). DO NOT CUT the rubber ring that holds the
speaker wire. Next, remove the screw, nut, and washer from the assembly clamp (#2). Carefully spread the
assembly clamp so it can go around the sound lens rubber ring. Place the assembly clamp around the sound
lens rubber ring leaving the 1 inch (2.54 cm) gap in the rubber ring exposed (#3). Reinstall the screw, nut
, and washer in the assembly clamp (#4).
1
Carefully place the Hayward face rim (chrome side down) on a non-abrasive surface, and place the speaker
and assembly clamp on the Hayward face rim (#5). Align the assembly clamp screw so that it does not
cover the mounting tab or the face rim lockscrew. Once aligned, tighten the assembly clamp screw until
the speaker is securely attached to the face rim (#6). Do not overtighten. The gap in the rubber ring will
be reduced.
2
Diluvio™ INSTALL- HAYWARD FACE RIM
Underwater Speaker- Hayward
Page 2 of 4
www.clarksynthesis.com