2
SMB-200 2-CHANNEL POWER AMPLIFIER
5-CHANNEL MIXER
4-CHANNEL POWER-
MIXER-AMPLIFIER
Booster
Output
FIGURE 1
Clarity
Audio
Output
Environment
Temperature
0 to 50°C
Humidity
0 to 85% non-precipitating
DESIGN
The SMB-200 100 Watt 2-Channel Amplifier is
designed to provide 100 watts of audio power in the
2-channel mode or 200 watts in the bridge mode.
The SMB-200 amplifier can be used to operate 2
Ohm speaker loads in the 2-channel mode or a 4
Ohm load in the 200 watt bridge mode.
The amplifier has an input volume control for each
channel located on the back of the unit.
Circuit breakers are provided on the back of these
units and will operate in the event of a catastrophic
overload. The 2-channel amplifier contains limiting
circuits for protection against short circuits or
impedance mismatches. The units will shut down in
the event of a trouble condition and reactivate
automatically when the condition is corrected.
The amplifiers can be either shelf or rack mounted
(rack mount kit is optional).
INSTALLATION
General
Figure 2 shows volume control locations. Figure 3
shows output terminal strips and switches on the back
of the amplifier as well as typical connections to a
mixer-amplifier.
Mounting
The SMB-200 is designed for shelf or rack mounting.
Make certain the unit is not mounted near heat
sources or strong magnetic fields. Verify control and
terminal strip accessibility. The unit may be rack
mounted. Order the associated rack mount kit
SMA-RMK.
Input Connections
High impedance auxiliary devices such as mixers,
equalizers, mixing boards, etc. can be connected to
channel A or B. Phono jacks are provided at the rear
of the amplifier for each channel input.
Speaker Cabling
Standard two conductor speaker wire can be used
(14-20 AWG determined by the load).
Amplifier Setup
During initial system set up, it is recommended that
the channel A and B input gain controls be set 1/4
turn clockwise.
