VRX653R
49
English
Installation and Wire
connection manual
1.
When the rear of the main unit has been
secured with the method shown in Figure 6
unfasten the special screw.
2.
Remove the outer escutcheon.
3.
Insert the hook plate between the spring
and the universal mounting bracket, fit tab
B
of the spring into hole
A
of the hook
plate, then pull the main unit out by the
hook plate. (Insert both the right and left
edges of the hook plate.) (Figure 9)
Note:
Keep the hook plate. You cannot remove
the main unit without disengaging the hook
plate.
6.
REMOVING THE MAIN UNIT
1.
Be sure to turn the power off before wiring.
2.
Be particularly careful where you route the
wires.
Keep them well away from the engine, and
exhaust pipe, etc. Heat may damage the
wires.
3.
If the fuse should blow, check to see if the
wiring is correct.
If it is, replace the fuse with a new one with
the same amperage rating as the original.
4.
When any fuse is to be replaced, pull out
the fuse (15A) at the rear of the main unit
and put in a new one (Fig.10).
After the connection, fix the lead by a clamp
or insulation tape for protection.
7.
CAUTIONS ON WIRING
CAUTION
Figure 10
