5. WIRING
1
Lead the camera cable into the vehicle and align it along the vehicle weather stripping. Fix the wires in
place and prevent them from being pinched in hinges or dampers.
2
Using an optional extension cable, the camera cable can be installed under the vehicle floor (carpet) to
connect to a Clarion rear-view monitor.
Exclusive waterproof relay cable (sold separately)
Inside the vehicle
Outside the vehicle
Securely tighten the connectors.
CMOS camera
Monitor for
Clarion rear-view
CCA-532-100 (7 m)
CCA-533-100 (10 m)
CCA-534-100 (15 m)
Use:
When used as part of a Clarion vehicle-mounted rear-view camera system, the rear-
view image is displayed on the monitor when the vehicle’s transmission is placed in
reverse, or when the monitor’s manual switch is used.
■
Waterproof Connector Fastening Procedure and Cautions
1
w
Mark : Align the arrow marks on both connectors in order to connect the cable.
Exclusive waterproof
relay cable (female)
Camera cable (male)
2
Hold the two connectors together and twist the ring on the camera cable’s connector as far as it will go.
Twist the ring in the direction
of the arrow while holding both
connectors together.
Twist the yellow ring until there is no gap between the ring and the connector.
Should
∫
ïhere be any gap between the ring and the connector, twist the ring to close it.
Gap
Note:
• See the Instruction Manual supplied with the
monitor for information regarding wiring, operation,
and composition of the monitor unit.
CAUTION
7. SPECIFICATIONS
Power source/voltage:
DC 9 V (±0.5 V)
Power consumption:
100 mA or less
Image sensor:
1/4" color CMOS
Angle of view:
130° (horizontal)
98.8° (vertical)
Minimum subject illumination:
3 LUX or less
SN ratio:
36 dB or more
Weight:
About 80 g (bracket and 0.5 m cable)
Dimensions:
24 (W)
×
24 (H)
×
22 (D) mm
Note:
• Specifications and design are subject to change without notice for further improvement.
6. TROUBLESHOOTING
Symptom
No image
Poor image is produced
Reason
Wiring is incomplete or disconnected.
A fuse is burned out.
The lens cover is soiled.
Sunlight or headlights from a vehicle
in the rear are shining directly in the
camera.
The environment is too dark.
The level of illumination outside the
vehicle changed too abruptly.
Solution
Check wiring once again and confirm
correct connections.
When using an independent power
supply box, check the fuse and, if
burned out, replace with a new one
of the same capacity (1 A). If the fuse
burns out repeatedly, consult your
dealer or nearest Clarion Service
Center.
Wipe lightly with a damp soft cloth.
Do not rub harshly with dry cloths
since scratches may be produced.
The image will return to normal when
the light striking the lens is removed.
The image display will be poor at
night or in dim light.
The image will return to normal in
conditions of brighter illumination.
When moving from a bright to a
dark location (especially from bright
sunlight to shade), the image may
appear excessively dark.
When moving from a dark to a bright
location (especially from shade into
bright sunlight), the screen image
may appear excessively bright.
This model CC4100E is following the provisions of Directive
2004/108/EC and Directive 2004/104/EC.
Authorized Representative
Clarion Europe S.A.S.
Z.I. du Pré à Varois, Route de Pompey, 54670 Custines, France
telephone: +33 (0)3 83 49 44 00 facsimile: +33 (0)3 83 49 44 21
